Troubleshooting - Clarion CMD4 Manual De Instrucciones

CD Changer Operations
Random play
Random play selects and plays individual tracks
on the disc in no particular order. This function
continues automatically until it is cancelled.
1. Press the [RANDOM] button.
2. To cancel random play, press the [RANDOM]
button again.

8. TROUBLESHOOTING

Problem
Power does not
turn on.
(No sound is
produced.)
No sound output
when operating
the unit with
amplifiers.
Nothing happens
when buttons are
pressed.
No audio.
Compact disc
cannot be loaded.
Sound skips or is
noisy.
Sound is bad
directly after
power is turned
on.
Source selection
does not
recognize CeNET
source
connection.
Cause
Fuse is blown.
Incorrect wiring.
Amplifier turn-on lead is
shorted to ground or
excessive current is required.
The microprocessor has
malfunctioned due to noise,
etc.
The speaker protection
circuit is operating.
Another compact disc is
already loaded.
Compact disc is dirty.
Compact disc is heavily
scratched or warped.
Water droplets may form on
the internal lens.
The microprocessor has not
stored the proper CeNET
information.
The CeNET cable is not
connected properly.
Disc random play
The disc random play selects and plays
individual tracks or discs automatically in no
particular order. This function continues
automatically until it is cancelled.
1. Press and hold the [RANDOM] button for 1
second or longer.
2. To cancel disc random play, press the
[RANDOM] button again.
Measure
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
Turn the unit off and check each wire for a possible
short. If the amplifier turn-on lead shorts out, cover it
with insulation such as tape.
Open the front panel by
pressing the [OPEN] button.
Press the reset button for
about 2 seconds with a thin
rod.
1. Check the speaker connection.
2. Turn down sound volume. Function can also be
restored by turning the power off and on again.
3. If the sound is muted again, consult your store of
purchase.
Eject the compact disc before loading the new one.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no scratches.
Let dry for about 1 hour with the power on.
Perform a system check.
See "Operations Common to Each Mode",
performing a system check section.
Ensure the CeNET cables are properly connected.
Reset
button
21
CMD4