LEMAN SSP210 Manual De Instrucciones página 22

2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes
When the carbon brushes are worn out, the power tool switches itself off. The power tool must then be sent to
an after-sales service agent.
When you have to replacement the carbon brushes by yourself, please following the order ：
- Disassembling
(1) Loosen the 9 screws ST4.2 on the main handle cover (62) (Fig 11), and remove the main handle cover
(Fig 12).
(2) Lift out the brush holder together with the carbon brush, while being very careful not to forcibly pull the
lead wires within the brush holder (Fig 13).
(3) Withdraw the insert piece, and remover the carbon brush from the brush holder.
- Reassembling
(1) Place a new carbon brush into the insert piece, and connect the brush terminal to the carbon brush.
(2) Return the brush holder and other parts to their original positions.
(3) Place the lead wire in the specified position. Be very careful not to allow the lead wire to contact the
armature or rotating parts of the motor.
(4) Replace the main handle cover, while being careful to ensure it does not pinch the lead wire, and
secure it firmly with the six screws.
CAUTION:
Should the lead wire be pinched by the main handle cover or come in contact with the armature or rotating parts
of the motor, a serious danger of electric shock to the operator will be created. Exercise extreme caution in
disassembling and reassembling the motor, following the above procedures exactly.
Do not attempt to disassemble any parts other than those necessary to effect replacement of the carbon brush.
5. Cleaning
Keep the ventilation slots clear and regularly clean the housing with a soft cloth.
CAUTION:
Repair, modification and inspection must be must be carried out by a LEMAN Authorized Service Center.
In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country
must be observed.
MODIFICATIONS:
LEMAN Power Tools are constantly being improved and modified to incorporate the latest technological
advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed without prior notice.
Do not dispose of electric tools together with household waste material!
In observance of European Directive on waste electrical and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
GB
DISPOSAL
20