Evolution HULK PETROL COMPACT24HP Manual De Instrucciones página 14

Fig. 2
Fig. 3
14
• Carefully slide the Middle Section over the lower
handles and align the holes.
• Insert the long thumb screws through the holes in
the middle handle, through the holes in the lower
handles and screw them into the captive nuts in the
cross-bar/cable store. (Fig. 2)
• Tighten these screws securely.
The two (2) short thumb screws are used to attach the
Upper Section of the handle to the Middle Section.
• Carefully slide the Upper Section of the handle over
the Middle Section and align the holes.
• Insert the thumb screws through the Upper Section
handle and screw them into the captive nuts within
the Middle Section.
WARNING: Take care to ensure that the power
cable from the Safety Switch down to the motor is
'free' and not 'trapped' during the assembly process.
Initial filling and checking the oil level –
Hulk Petrol
WARNING: This machine does not come filled
with oil. No attempt to start the engine must be
made until the crankcase is filled to the correct level
with the correct grade of oil.
Note: Oil (provided) should be poured into the
machine through the Oil Filler/Level Cap. Oil capacity
is approximately 0.25 litre of 10W 30 automotive oil
(available at all good motor factors and most petrol
stations). For some non-temperate climatic areas an
alternative grade of oil may be preferable – consult
your supplier.
The Oil Filler Cap unscrews from the machines engine
casing and incorporates an oil level dip stick. (Fig. 3)
Take care not to spill any oil.
Note: It is important that when checking the oil level
the machine is on a stable, horizontal and level surface
with the engine stopped and cold.
Two index marks are provided on the dipstick.
The oil level should be maintained at or near the
upper index mark.
www.evolutionpowertools.com