Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Cleanarea around oil fill, remove oil fill cap/dipstick.
Wipe dipstick clean.
4.
Tip your pressure washer to drain eli from eli fiii into a
suitabie container making sure you tip your unit away
from spark plug. When crankcase is empty, return
pressure washer to upright position.
5.
Slowly pour recommended oil (about 20 oz.) into oil fill
opening. Pauseto permit oil to settle. Fill to "Full" mark
on dipstick.
6.
Wipe dipstick clean each time oil level is checked. DO
NOT overfill.
7.
Replaceand tigllten dipstick.
8.
Wipe up any remaining eli.
g.
Reconnect spark plug wire to spark plug.
Service Air Cteaner
Your engine wiil not run properly and may be damagedif you
run it with a dirty air cteaner.
Service the air cleaner once every 25 hours of operation or
once eachyear, whichever comes first. Service more often if
operating under dirty or dusty conditions. Replacementsare
available at your local Sears service center.
Teservice the air cleaner,follow these steps:
1.
Loosen two screws (A) and lift off cover (B).
2.
Carefully remove air cleaner (C) from base (D).
3.
Instati ciean (or new) air cleaner in base. Air cleaner
must fit securely in base.
4.
Place cover over air cleaner and tighten screws.
NOTE:You can purchase new air filter elements by caIling
l=800o4=MY=HO_,IE (459-4663).
Service Spark Plu9
Service the spark piug every 1O0hours of operation or
yearly, whichever occurs first.
1.
Cleanarea around spark piug.
2.
Removeand inspect spark plug.
3.
Repiacespark plug if electrodes are pitted, burned or
porcelain is cracked. Use the recommended replacement
plug. See Specifications.
4.
Checkelectrode gap with wire feeler gauge and set spark
plug gap to 0.020 inch (0.50 ram) if necessary.
//
5.
Instali spark piug and tighten firmly.
NOTE:You can purchase a new spark plug by calling
l=800o4=MY=HOME ( 469o4663).
Spark Attester Service
Your engine is not factory=equippedwith a spark arrester. In
some areas, it is iiiegai to operatean engine without a spark
arrester. Check iocai iaws and regulations. A spark attester is
avaiiable from your nearest Sears service center, if you need
to order a spark arrester, please call 1-800-4-MY-t-tOME
(469=4663).
The spark arrester must be serviced every 50 hours to keep it
functioning as designed.
If the engine has been running, the muffler wiii be very hot.
Ailow the muffler to cool before servicing the spark arrester.
WARNING
_
ontact with muffler area can resuit in serious
burns.
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
o DO NOTtouch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touchh]g.
o Keep at least5 feet (152 cm) of clearance on all sides of
pressure washer including overhead.
• Code of Federal Regulation (CFR)Title 36 Parks, Forests, and
Public Property require equlprnent powered by an inten]al
cornbustion engine to have a spark arrester rnaintained in
effective working order, complying to USDAForest service
stal]dard 5100-16 or later revbion. In the State of 6alifornia a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
Remove spark arrester screen for cleaning and inspection.
•
Replace if screen is damaged.
18
Tabla de contenido
