Connection To Home Page - FlexWATCH FW-3850 Manual De Usuario

FlexWATCH User Manual Part 2
5.
To check whether your Network configuration is correctly applied or not, press 'ifconfig'
command, then following messages will show up. On the second line of the 'eth1'
message, you can check the assigned IP and Mask values. Gateway value is not seen
here. If the values are different from what you want to set-up, try again the Network
configuration from step 4.
Bash# ifconfig
eth0
Mask:255.255.255.0
eth1
Mask:255.255.255.0
lo

2.4.3. Connection to Home Page

Run Internet Explorer Browser and enter the IP address. Then it will connect to the homepage of
FlexWATCH server.
M4028
Link encap:Ethernet HWaddr 00:30:6F:48:64:86
inet addr:10.20.30.40 Bcast:10.20.30.255
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:9
Link encap:Ethernet HWaddr 00:30:6F:48:E4:86
inet addr:192.168.0.253
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1453 errors:0 dropped:0 overruns:0 frame:0
TX packets:62 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:10 Base address:0x2100
Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:309 errors:0 dropped:0 overruns:0 frame:0
TX packets:309 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
Bcast:10.255.255.255
25 Seyeon Tech Co., Ltd