Tabla de contenido
FlexWATCH User Manual Part 2
3.
Input 'netconfig eth1 IP, SubnetMask, Gateway', and press Enter key as below.
(e.g. bash# netconfig eth1 192.168.0.253 255.255.255.0 192.168.0.1)
TIP) 'Eth1' is to set up IP at 'WAN Port'. If you type in eth0, it will set up IP at 'LAN Port.'
4.
Please save all the changed settings for IP, subnet mask and Gateway into flash
memory by
bash#
bash#
savecfg
Saving a current config to flash memory
[ OK ]
Updated flash
bash#
M4028
bash#
netconfig eth0 192.168.0.253
255.255.255.0 192.168.0.1
Your network configuration was changed.
Shutting down interface ppp2 [ OK ]
Shutting down interface ppp1 [ OK ]
Shutting down interface eth1 [ OK ]
Shutting down interface eth0 [ OK ]
Disabling IPv4 packet forwarding [ OK ]
Setting network parameters [ OK ]
Bringing up interface lo [ OK ]
Bringing up interface eth0 [ OK ]
Bringing up interface eth1 [ OK ]
Bringing up interface ppp1 [ OK ]
Your new network configuration was applied.
bash#
'savecgf'
shown as below.
24
Seyeon Tech Co., Ltd
Capítulos
Tabla de contenido
