8A-1-10 HOW TO USE THIS MANUAL
3. · Wiring of this vehicle uses joint connectors (J/C) which divide one wire into several different wires or combine several
different wires into one wire.
· The joint connector is illustrated below.
How to Read Connector Codes and Pin Nos. (How to Use Manual) :
It is possible to retrieve the location and shape of each connector from the connector code indicated in "SYSTEM
CIRCUITDIAGRAM" section and the position of each pin from the connector pin No.
To retrieve location of connector :
Open "SYSTEM CIRCUIT DIAGRAM" section to consult the connector code of the questioned connector. Then, refer to
"CONNECTOR LAYOUT DIAGRAM" section and look for the same code as the connector code in question. The place
where the code is found is the location of that connector.
To retrieve shape or pin No.
Open "SYSTEM CIRCUIT DIAGRAM" section to consult the connector code and pin No. of the questioned connector.
Then, refer to "LIST OF CONNECTORS" section as shown at the right in the figure below and look for the desired
connector code under which the shape of that connector is shown. This method is convenient when locating the connec-
tor in question among similar connectors. Also, by using this page, it is possible to find the position of each pin from the
connector pin No. provided in "SYSTEM CIRCUIT DIAGRAM" section.
It is helpful when retrieving pin position in the connector for checking continuity between pins.
To know the location, shape or pin position of the connector, cross-refer "SYSTEM CIRCUIT DIAGRAM", "CONNECTOR
LAYOUT DIAGRAM" and "LIST OF CONNECTOR" section as follows:
CONNECTOR LAYOUT DIAGRAM
Retrieve the connector location
SYSTEM CIRCUIT DIAGRAM
Consult the connector code and
pin No.
CROSS-REFERENCE
LIST OF CONNECTORS
Retrieve shape or pin position
of the connector.
Capítulos
