Tabla de contenido
10 von 25
The arrow embossed on the top of the plinth points to the front, see Fig. 1.
A
Level the plinth on the floor.
A
Mark the hole positions.
A
Drill holes measuring 12 mm in diameter in the marked positions, to a depth of approximately 65 mm.
A
Insert plugs (5) into the holes, see Fig. 2.
A
Line the plinth up with the underlay supplied (4), see Fig. 2.
A
Fasten the plinth to the floor with the hexagonal-head wood screws (1), 8.4 washers (2) and 15 x 44 x 3 washers (3),
see Fig. 2.
Fitting a washing machine to the plinth
A
Fit the tensioning strips on the plinth and fasten them in the appropriate holes (1), see Fig. 3.
A
Secure each tensioning strip to the plinth with 1 M6 x 30 bolt (1), 2 galvanised B6.4 washers (2) and 1 M6 nut (3). Do
not tighten the nuts yet, see Fig. 4.
A
Unscrew the washing machine feet by at least 5 mm.
A
Set the washing machine down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the washing machine on the plinth.
A
Use the tensioning strips to fix the washing machine to the front feet, see Fig. 4.
A
Fit another M6 nut (4) to each of the feet to counter the first nut, see Fig. 4.
A
Screw 1 M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 5.
Fitting a tumble dryer to the plinth
A
Unscrew the tumble dryer feet by at least 5 mm.
A
Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A
Level the tumble dryer on the plinth.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten, see Fig. 6.
Fitting the plinth panels
A
Use four M4 x 25 screws to attach each of the two side panels, see Fig. 7.
A
Use four M4 x 25 screws to attach the front panel, see Fig. 7.
en
en-US
APCL 15/30 stand installation instructions
Reason: Installing a washer or dryer on a stand enables a more ergonomic height to be achieved.
Parts included
Quantity Mat. no.
Designation
1
Stand
2
Clamp
4
B6.4 washer
2
M6 x 30 bolt
4
M6 nut
4
S12 plug
20.01.2020
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 11313351
Tabla de contenido
