Preparing For Use; Installing The Cut-Off Wheel - Norton Clipper CP512-300 Manual De Instrucciones

Preparing for use

5.1

Installing the cut-off wheel

The cut-off wheels used must correspond to the specifications from chap. 7.1 on page 26!
The power tool spindle is designed for cut-off wheels with an inner bore of 20 mm.
Cut-off wheels with 1" inner bores must only be installed together with the spindle adapter disk.
Installation of cut-off wheels with 1" inner bore:  Chap. 5.2, page 17!
When using cut-off wheels with an inner bore of 20 mm, no additional spindle adapter disk is
required.
a
• For cut-off wheel installation, the power tool must be put securely on the ground. Securely hold the
power tool at the top handle with the left hand and push it firmly onto the ground.  Chap. 5.4, page 18
• Insert blocking pin (a) entirely into the cut-off wheel blocking opening (12) to block the spindle.
Unscrew cut-off wheel attachment screw (11). Remove wheel (b) and outer mounting flange (c).
1
b
11
c
• Put cut-off wheel (1) on spindle.
For cut-off wheels with specified rotating direction (arrow on the cut-off wheel), observe correct
alignment of the cut-off wheel during assembly (for rotation direction of the cut-off wheel, see above).
ENGLISH 16
5 Preparing for use
b
12
c
Rotating direction
of cut-off wheel
The rotating direction of the cut-off wheel is always
as indicated by the arrow above – independently of
whether the cutting device is installed in the center
or outer position.