Zanussi ZWI 71000 WA Manual De Instrucciones página 16

STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button Inicio/Pausa.
The corresponding indicator stops to flash.
The phase indicator Prelava./Lava. illuminates and
stays on.
The programme starts and the door locks.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START OPTION
1. Press the button Inicio Diferido repeatedly to
set the required delay.
The indicator of the set delay comes on.
2. Press the button Inicio/Pausa:
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the delay
setting before you press the button
Inicio/Pausa. After pressing the button
Inicio/Pausa, you can only cancel the
delay.
To cancel the delay start:
a. Press the button Inicio/Pausa to set the
appliance to pause.
The corresponding indicator flashes.
b. Press the button Inicio Diferido once; the
indicator of the set delay goes off.
Press the button Inicio/Pausa again to start
the programme immediately.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
16
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press the button Inicio/Pausa.
The indicator flashes.
2. Change the options.
3. Press the button Inicio/Pausa again.
The programme continues.
OPENING THE DOOR
While a programme or the delay start operates, the
appliance door is locked.
CAUTION! If the temperature and
level of the water in the drum are too
high and the drum still rotates, you
cannot open the door.
To open the door during the first minutes of the
cycle or when the delay start operates:
1. Press the button Inicio/Pausa to pause the
appliance.
2. Wait some minutes until the door unlocks.
3. You can open the door.
4. Close the door and touch the button Inicio/
Pausa again. The programme (or the delay)
continues.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The indicator of the button Inicio/Pausa goes
off. The phase indicator Fin/Fim illuminates and
stays on.
• Turn the programme knob to position
deactivate the appliance.
• After some minutes you can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
to
• Close the water tap.
• Keep the door and the detergent drawer ajar, to
prevent the mildew and odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator
• The indicator Inicio/Pausa flashes to remind you
to drain the water.
• You must drain the water to open the door.
Draining the water:
1. Set a draining (Descarga) or a spinning
(Centrifugar) programme.
2. Press the button Inicio/Pausa.
The appliance drains the water and spins.
stays on.
to