Cuenod NC9 GX207/8 Instrucciones De Montaje página 46

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Start up
Settings
Gas valve
pBr
Pressure
controller
setting
S 20 = from 40 to 200 daPa
Locking
screw
46
F4
Pressure switch
Y13 Nominal valve
Y14 Valve (2
Y15 Safety valve
104 Pressure controller
106 Filter
119 Pressure take offs
Gas pressure switch setting
· Remove the transparent cover.
The device includes an index x and
a graduated mobile disc.
· Adjust the pressure switch temporarily
at the minimum value read on the
graduated disc.
Controller setting:
Controller pressure measurements are
carried out at pBr.
The pressure setting provides the
desired flow rate.
Incremental advance setting
This hydraulic brake function acts on
incremental advance and stage change.
Painted screw
· Unscrew plastic stopper B.
· Turn it around and use it as a
spanner.
· Rotate it in the direction of the:
- arrow: the progressive rate will
+ arrow: the progressive rate will
Setting the stage one flow rate
· Unscrew the locking screw without
touching the painted screw opposite.
· Rotate crown D clockwise by hand
(without using a tool): the flow rate
will decrease and vice versa.
· Tighten the locking screw back up.
06/2004 - Art.Nr. 13 011 288C
d
stage)
increase
decrease.
General setting procedure
The setting for stage two is only carried
out by actuating the pressure controller:
the stage two valve (button C) is open to
its maximum extent.
The progressive rate upon ignition and
changing from one stage to another is set
by actuating button B.
The setting for stage one is carried out by
actuating crown D.
Particular case
Nominal flow stage setting
This is necessary only if the flow stage
read under a pressure of 40daPa on
the controller is too high.
Do as follows:
· loosen the locking screw avoiding to
touch the opposite painted screw.
Plug C has a 4.5-turn travel length.
· Make the screw rotate in a cw
direction arrow -:
the flow stage decreases and vice
versa.
It might be necessary to adjust the
pressure.
· Tighten the locking screw back up.
Tabla de contenido
loading

Tabla de contenido