Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mecatecno motorbikes are designed to work with 24 volts (T8) and 36 volts (T12), using
higher voltage would cause damage to the engine. Any modification to the motor would
void the warranty in its entirety. Improper use of the battery, such as an incorrect charge,
improper storage or use of the battery in another motorbike or other machine, will also
void the warranty. All of these activities can also cause dangerous situations.
Keep the battery away from excessive heat, including prolonged exposure to the sun.
Also keep the battery away from water and any other liquid. Dry the battery as soon as
possible if it gets wet in the rain. Remove the battery from the motorbike before washing
it. Never apply strong pressure, blows or excessive vibrations to the battery.
The accessible parts do not have sharp edges, angles or surfaces that could hurt the
rider.
The battery life was calculated in a series of tests at half throttle and considering the
child's weight. The battery life can vary depending on how the motorbike is used.
24
5.4.2 Installation
1. Make sure engine is off
2. Put batteries in place
3. Connect terminals
4. Put battery cover in place
T8: 2 - 12 volt batteries in series connected to the
motorbike's terminal
T12: 3 - 12 volt batteries in series connected to the
motorbike's terminal
5.4.3 Storage
If the motorbike is not going to be used over an
extended period of time, the batteries must be
removed fully charged.
5.2.4 Recycling
Once the batteries wear out, they should be dis-
posed of properly. Information is usually available
regarding recycling centers at your city hall.
5.5 Maintenance
5.5.1 Front wheel
To install the front wheel, follow the next steps:
1.- Make sure the engine is turned off.
2.- For the Mecatecno T8, disconnect the V-brake
cable (front) by pressing together the two sides
and releasing the end of the cable from the brake
pad.
3.- Loosen the axle nuts and remove the wheel
from the fork.
4.- Reinstall the wheel by following the process in
reverse. Verify the alignment is correct and that
the tire turns freely. Make sure the nuts are tightly
fastened.
TIRE PRESSURE (RECOMMENDED):
DRY
WET
OUTING
0,45 bars
0,41 bars
0,55 bars
5.5.2 Front brake
The front brake adjustment is different for models
T8 and model T12.
For the Mecatecno T8:
1.- Adjust the vertical height and rotation of each
brake pad using an Allen wrench and leaving the
brakes centered on the rim.
2.- Once the brake pads are in position, tighten
them into place. The brake pads should not touch
the tire or go below the rim.
3.- Loosen the screw that holds the brake cable
using an Allen wrench.
4.- Make sure the end of the cable (the curved
tube) is correctly placed in the brake lever con-
nection.
5.- Verify that the black protective rubber tube
does not strangle the brake cable connection.
6.- Tighten the two arms of the brake pads by pu-
lling on the end of the brake cable until each pad
is situated 2mm from the rim.
7.- Tighten again the brake cable using the Allen
wrench 5mm and check that the cable does not
move by firmly pressing the brake lever several
times.
25
Tabla de contenido
