Saturation Index Calculation Menu; Alarms; Temperature Probe Alarm - Aqua SALT Cella 50 Manual De Instrucciones

AQUA SALT
Salt chlorine generator
The Saturation Index Calculation menu calculates an indicator of pool water balance. By adding pH,
4.5.11
hardness and alkalinity values, it is possible to determine if the water of the pool is in good condition.
Saturation
Press and hold Enter for 1 second to go back to the "SI calculation" section of the User Menu.
index
calculation
menu
Insert here the pH value of the water.
pH
Insert here the hardness value of the pool water, expressed in ppm within the range 75-800
Water hardness
Insert here the total alkalinity value of the pool water, expressed in ppm within the range 75-800
Total alkalinity
This field indicates the saturation index value (SI) within the range -9.9...+9.9, with an indication
SI
about water quality among: Perfect/Good/Corrosive/Fouling

5 Alarms

The temperature probe alarm can be enabled/disabled from the Alarms Menu, selecting On/Off. If it is
5.1
enabled, the alarm goes off when a temperature value outside the range is read. This may also indicate a
probe fault or the absence of the probe on the connector.
Temperature

The device indicates:
probe alarm



During the alarm, the generator continues its normal work.
The alarm is automatically reset when the probe is connected or replaced in case of faults, or by
disabling the alarm from the Alarms Menu.
ADSP7000648
The alarm signal
to the main section of the User menu, while the audible alarm (if
enabled) and the corresponding Led (Alarm or Maintenance Led) will
be enabled for all menus
Audible signal with the buzzer, if enabled (see Audible Alarm in the Alarms Menu);
Red alarm LED steady on;
"Temperature probe Alarm" flashing on the display;
rev. 1.4
MAINTENANCE AND INSTRUCTION MANUAL
pH
Water
SI
Hardness
Total
alkalinity
with the highest priority will be visible alternately
31/07/2017
ENGLISH
84
84/264