Tabla de contenido
ENGLISH
MOUNTING
instructions for mounting tires
» Lubricate the tire beads (fig.22).
» Rest the tire on the rim.
» Lower the head column and move the head into the working position
resting the bead on the edge of the head and under the tongue.
» Rotate the chuck pressing the inverter pedal and taking care to insert
the bead into the central rim-well so as to avoid over straining the
bead. This operation should be assisted by pushing on the tire with the
hands (fig.23).
» Position the rim with the hole for the inner-tube valve at 90º to the head.
Insert the inner-tube (unnecessary with tubeless tires).
intermediate
» Position the upper roller (with mechanical hand) and the lower roller
(with mechanical hand) as close as possible to the rim flange (see
control panel) (fig.24).
» Position the helper so that it keeps the tire in the rim-well (fig.25).
» Rotate the chuck pressing the inverter pedal until the tire is fully in-
switch
serted into its seating (fig.26-27).
» Raise the head column, move away the bead breaking rollers and
helper and then press the pedal to release the rim.
» Inflate using the inflation gun (fig.28)or with the tubeless inflation kit
(fig.29)(depending on the type of tire) up to the correct pressure.
» Release the rim from the flange by unscrewing the wing nut and remov-
ing the fixing cone.
» Raise the tire using the lift control pedal and return the wheel to the
floor.
ALUMINIUM AND LIGHT ALLOY RIMS
To mount tires onto aluminium or light alloy rims, follow the normal mount-
ing procedure (described above).
Important: with low-profile tires (45 / 40 / 35 ) the mounting of the 2nd
bead might prove difficult. If so proceed as follows:
»
Move the upper roller to the side of the tire.
»
Rotate the chuck plate until mounting is complete.
To release the rim:
»
Raise the head column.
»
Unscrew (and remove) the fixing screws and free the rim.
22
24
COD. 104064 Rev.0
730 PRO
23
25
12
Tabla de contenido
