lauson CL136 Manual De Instrucciones página 30

Remark :
- DUE TO THE LENGTH OF THE RECORD IS VARIOUS, IF YOU FIND THE TONE ARM CANNOT
RETURN AUTOMATICALLY AFTER PLAYBACK OF RECORD. PLEASE PRESS THE EJECT
BUTTON AND RETURN THE TONE ARM BACK TO THE REST POSITION
- USERS SHOULD NOT CHANGE TO A MAGNETIC CARDRIDGE SYSTEM, OTHERWISE UNIT
CAN´T BE CONNECTED ANYMORE TO AN AUX-IN OF MUSIC-CENTER
ADJUSTMENTS
ANTI-SKATING CONTROL
- THE ANTI-SKATING CONTROL (29) IS MADE THE STYLUS MORE STABLE AND THIS RELATIVE TO THE
DIFFERENT TYPE OF VINYL, THUS, JUST SET IT TO THE COMFORTABLE POSITION AS YOU DESIRED.
PLATTER SPEED ALIGNMENT
- DURING PLAYBACK OF RECORD, OBSERVE THE APPROPIATE STRIP OF STOBE CALIBRATION DOTS
FROM THE STROBE LENS. THE UPPER ONE IS FOR 33 RPM AND THE MIDDLE ONE IS FOR 45 RPM.
- IF THE STROBE DOTS APPEAR TO FLOWING TO THE RIGHT, IT MEANS THE PLATTER IS REVOLVING
SLOWER THEN RATED SPEED. TURN THE PITCH CONTROL (33) TO THE " + " DIRECTION. IF THE
STROBE DOTS APPEAR TO FLOWING TO THE LEFT, IT MEANS THE PLATTER IS REVOLVING FASTER
THAN RATED SPEED. TURN THE PITCH CONTROL (33) TO THE " – " DIRECTION.
- ADJUST THE PITCH CONTROL (33) UNTIL THE STROBE DOTS DO APPEAR TO BE STATIONARY WITHOUT
MOVING LEFT OR RIGHT.
TONE ARM STOPPING POSITION ALIGNMENT
- THE POSITION OF THE TONE ARM COMPLETE PLAYBACK AND RETURN TO THE REST STATION CAN BE
ADJUSTED AT THE ALIGNMENT SCREW (27) AS FOLLOW:-
- BEFORE STARTING THE ALIGNMENT, PLEASE TAKE OUT THE HOLE COVERING RUBBER:-
A) IF THE SYSTEM CANNOT COMPLETE THE PLAYBACK OF RECORD AND RETURN EARLIER
1) USE A CROSS HEAD SCREW DRIVER AND TURNING THE ALIGNMENT SCREW (27) INSIDE THE HOLE
CLOCKWISE, THE STOPPING AND EJECT POSITION OF THE TONE ARM WILL MOVE MORE INWARD TO THE
CENTER OF THE RECORD BEFORE PLAYBACK COMPLETION.
B) IF THE SYSTEM CANNOT RETURN TO REST POSITION AUTOMATICALLY AFTER PLAYBACK OF RECORD
2) USE A CROSS HEAD SCREW DRIVER AND TURNING THE ALIGNMENT SCREW (27) INSIDE THE HOLE
ANTI-CLOCKWISE, THE STOPPING AND EJECT POSITION OF THE TONE ARM WILL MOVE MORE AWAY FROM
THE CENTER OF THE RECORD BEFORE PLAYBACK COMPLETION.
REMARK:-
- THE STOPPING POSITION IS VERY SUBJECTIVE AMONG DIFFERENCE CUSTOMERS, PLEASE SELECT
THE MOST SUITABLE POSITION BASED ON YOUR OWN RECORD COLLECTION. THE EX-FACTORY
SETTING IS BASED ON THE MOST COMMON TEMPLATE.
- PLEASE CHECK THE STOPPING POSITION TIME BY TIME DURING ADJUSTMENT AND AVOID OVER
TURNING OF THE SCREW INSIDE.
GB-8