Assembly - Urrea SB1118 Manual De Usuario

8. BLADE GUIDE ADJUSTMENT HAND WHEEL.
9. BLADE GUIDE.
10. RIP FENCE ASSEMBLY.
11. UPPER DUST PORT 4".
12. FOOT BRAKE.
13. MOUNTING BOLT.
14. BLADE TRACKING KNOB.
15. QUICK RELEASE BLADE TENSION LEVER.
16. TABLE TILT KNOB.
17. SUPPORTING SPRING ASSEMBLY.
18. MOTOR.
5
1
6
2
7
3
4
MAGNETIC SAFETY SWITCH OPERATION
The magnetic safety
switch as shown as up Fig.
needs to be installed to
under side of the front
rail, see assembly section
in this manual for further
instructions.
Do not turn the cabinet saw on until all as-
sembly and adjustment instructions have been
done. To start the cabinet saw, press the green
start button (A) and to stop the cabinet saw,
press the red emergency stop button (B).

ASSEMBLY

ASSEMBLY INSTRUCTIONS
The band saw is supplied partly assembled.
Prior to use, the following items have to be
assembled.
8
9
10
11
12
13
A
B
E N G L I S H •
DISASSEMBLING FLOOR AMOUNTING BOLTS
To be safe,
mounting the band
saw to the pallet
for shipment,
firstly, you must re-
move the pallet and
slowly set the band
saw into position by
hardware.
You may also mount your machine to a mobile
base that has wheel locking or wheel retract-
ing capabilities that keep the mobile base from
rolling when not in use.
14
ASSEMBLING MOTOR
Firstly, you assemble motor (E) to the motor
flange (D) by hex bolt (A), lock washer (B) and
15
flat washer (C ) .
Secondly, assemble
them to the frame
by hex bolt (H), lock
16
washer (G) and flat
washer (F). Then ten-
17
sion the V-belt (E) by
motor gravity, Finally,
18
tighten the
(Fig.2).
After that, connect
the power cord (B)
into the junction box
(Fig.3-A).
ASSEMBLING WORKING TABLE
Release the
(Fig.4-A), then put the
working table assem-
bly into the trunnion
groove (B), adjust the
work- ing table move
freely, then pre-tight-
en the nut (C).
ASSEMBLING SPRING ASSEMBLY
Rotate the working
table 45°with
clockwise, then install
the spring assembly
into table bottom and
frame by hardware
(Fig.5-A,B,C)
U se r's m a n ua l
we
so
Fig. 1
Mounting hole
c
i
a
b
d
bolts
a
b
knob
b
a
anti-
c
b
Fig.5
a
b
Fig.2
e
d
h
f
g
Fig.3
Fig.4
b
c
13