Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Before connecting the tool to a power source
(receptacle, outlet, etc.) be sure that the volt-
age supplied is the same as that one specified
on the nameplate of the tool. To use a not
specified voltage may cause a serious injury to
the user as well as damage the tool.
TOOL USE AND CARE
• Use clamps or other practical way to secure
and support the workpiece to a estable plat-
form. Holding the work by hand or against your
body is unestable and may cause loss of control.
• Don't force the tool. Use correctly the tool in
its application and this will help you to do the
job better and safer.
• Do not use tools if switch does not turn it
ON or OFF. Any tool that cannot be controlled
whith the switch is dangerous and must be re-
paired.
• Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the tool.
• Store the power tool out of reach of children
and other untrained persons. Tools are danger-
ous in untrained hands of users.
• Maintain tools with care. Keep cutting tools
sharp and clean. Properly mainteined tools,
with sharp cutting edges are less likely to bind
and are easier to control.
• Check for misalignment or bonding of mov-
ing parts, breakage parts, and any other con-
dition that may affect the tools operation. If
you find a damaged tool, take it to the service
before use it. Many accidents are caused by
poorly maintained tools.
• Use only accessories that are recommended
by the manufacturer of your model. Suitable
accessories for one tool, may become hazard-
ous when are used on another tool.
• Do not alter or misuse the tool. These tools
have been built by precision. Any alteration or
modification not specified is misuse and may
result in a dangerous condition.
• Tool service must be perfomed only by quali-
fied repair personnel.
12
Service or maintenance performed by unquali-
fied personnel could result in a risk of injury.
• When tool service is required, use only identi-
cal replacement parts and follow the instruc-
tions from "Maintenance Section" in this man-
ual. The use of unauthorized parts or failure to
follow Maintenance Instructions may cause a
risk of electric shock or injury.
SPECIFIC SAFETY RULES
1. Always allow the band saw blade to stop be-
fore removing scrap pieces from table.
2. Always keep hands and fingers away from
the blade.
3. Never attempt to saw stock that does not
have a flat surface, unless a suitable support
is used.
4. Always hold material firmly and feed it into
the blade at a moderate speed.
5. Always turn off the machine if the material
is to be backed out of an uncompleted out.
6. Adjust the upper guide about "1/8" above
the material being cut.
7. Check for proper blade size and type for
thickness and type of material being cut.
8. Make sure that the blade tension and blade
tracking are properly adjusted.
9. Make "relief" cuts before cutting long
curves.
10. Release blade tension when the saw will
not be used for a long period of time.
FEATURES
BECOME FAMILIAR WITH THE SAW BAND
Before attempting to use this saw, become
familiar with all of its operating features and
safety requirements.
WARNING: Do not allow familiarity with the
table saw to cause a lack of alertness. A frac-
tion of second of carelessness is enough to
cause sever injury.
1. TENSION INDICATOR WINDOW.
2. MAGNETIC SWITCH.
3. TOOL STORAGE HOOKS.
4. FRAME.
5. BLADE TENSION LEVER.
6. BLADE TRACKING WINDOW.
7. IRON TABLE.
Tabla de contenido
