Orbegozo HPE 6075 Manual De Instrucciones página 18

HPE 6075
6. CLEANING
1. Unplug the power cable prior to cleaning.
2. Brush the bottom of the cooker with a mop. Never steep the cooker into water or spray water on
it.
3. Take off and clean the water collector and wash it with a wet towel.
4. Clean the inner side of the cooker, including the sealant washer, pressure discharging valve, anti-
blocking case, steam relief pipe, floating valve with water and clean it with a mop.
5. Use a sponge or nonmetal soft brush to clean the inner take and clean it with a mop.
6. Clean the seat of pressure limiting air relief valve and water drain hole with a small brush, so that
water can be freely discharged.
No. Symptom
1 Difficult to
cover
2 Difficult to
uncover
3 Steam
leaking
4 Floating valve
leaking
5 The floating
valve cannot
rise
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose
of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the requirements
of the EMC directive 2004/108/EC.
Diagnosis
The sealant washer is not well placed.
Floating valve stuck on the bar.
The floating valve is not down in place.
Sealant Washer is not in.
Dirty in the sealant washer
Damage sealant washer
The lid is not well fixed.
Dirt in the sealant washer, or floating
valve.
Damage to the sealant washer
Insufficient food in the cooker
Leakage in the lid or pressure displaying
Solution
Place the seal washer in a proper
position.
Push the bar slightly
Slightly press the valve with chopsticks.
Put in the sealant washer
Clean the sealant washer.
Replace the sealant washer.
Fix the lid in line with standard.
Cleaning the sealant washer of the
floating valve.
Replace the sealant washer.
Add food and water the line with
directions.
Send it to the maintenance shop.
18