Maytag 4KMEDC100 Manual De Uso Y Cuidado página 11

Secadora a gas o electrica
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TROU BLESHOOTING
(cont.)
First try the solutions suggested here to possibly avoid the cost of a service call.
Cycle time too short
Automatic
cycle ending early.
Lint on load
Stains on load or drum
Lint screen clogged.
Dryer fabric softener not properly
used.
The load may not be contacting
the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Automatic
Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Loads are wrinkled
Load not removed from dryer at the
end of the cycle.
Dryer tightly packed.
Odors
You have recently been painting,
If so, ventilate the area. When the odors or fumes are gone from
staining, or varnishing in the area
the area, rewash and dry the clothing.
where your dryer is located.
The electric dryer is being used for
The new electric heating element may have an odor. The odor
the first time.
will be gone after the first cycle.
Load is too hot
Laundry items were removed from
Allow Cool Down cycle to finish before removing laundry from
the dryer before the end of the cycle,
dryer. All cycles are cooled slowly to reduce wrinkling and make
it easier to handle. Items removed before Cool Down may feel
very warm.
A high temperature
cycle was used
Select a lower temperature
and use an automatic drying cycle.
or Temperature/Fabric
control was
These cycles sense the temperature or the moisture level in the
set to high.
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Use a cycle with Wrinkle Prevent to tumble the load without heat
to avoid wrinkling.
Dry smaller loads that can tumble freely and reduce formation of
wrinkles.
11
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

4kmedc300

Tabla de contenido