Network Settings; Scan For Networks; Wired/Wireless; Configure "My Stuff - Rotel RT-12 Manual De Instrucciones

16

NETWORK SETTINGS

Network Config
This section covers the setup procedue for wired or wireless LAN in
more detail.
Push the Network button to enter the main menu as shown
6 N
below.
< Internet Radio >
My Stuff
Media Player
Settings
Note: If you are unable to return to the above menu automatically after
entering Network mode, push the BACK
above menu.

Scan for Networks

From the main menu, select the Settings option then select Network Config.
Then select Scan for Networks option.(only available in wireless setup)
. Once the network is found, the display will show the network ID. Turn
the knob to select, push to confirm.
< Scan for networks >
Enter network name
View Config
Edit Config
Enter network name
( only for wireless connection)
If the unit can not find any networks, the network ESSID can be entered
manually .
Use the knob to keep selecting letters of the device name by turning and
pressing, and select "END" word to confirm the name
Network Name
< END <> A BCDEFGHIJK >
NAME1
View Config
Show current network configuration details. Turn the knob to see next/
previous page of "Mode"-->"ESSID"-->"MAC Address"--> "IP Address"
-->"Netmask"-->"Gateway"-->"DNS Servers". Display as below:
< Mode >
Auto DHCP
Edit Config
This menu can be used to edit the current network configuration. This
menu is useful for entering a static IP address. Select this function with
the knob and enter the static IP address, MAC address, DNS of the
selected network.
0 D button to get to the
< ESSID >
XXXXXX
To enter the value, press knob, then rotate the knob to adjust the value up
or down. Press again to enter the value and move on to the next field.
Continue until all information has been entered.
Signal Warning
( only for wireless connection)
Select YES or NO to enable or disable warning of low Wi-Fi signal.

Wired/Wireless

Select Auto (defaults to wired if both are connected), Wired only, or
Wireless only.
Version
This menu displays software and hardware information of the unit.
Upgrade Firmware
Use this option to download new firmware for the internet radio. If new
firmware is available, there will be a prompt to download.
Note: At this stage, you can press the BACK button to cancel the
firmware upgrade. A firmware upgrade may take several minutes,
do not switch off the power to the unit or put it into standby until the
operation is complete, otherwise, the unit may become permanently
damaged. Upgrading can take 15 to 60 mins, depending on the
speed of your internet connection.
Register
This will display a key that can be used to register the unit on the Rotel
Radio Customer portal: www.rotelradio.com
Set Time/Date
Set you local time and date. Push knob to start entering value, rotate
knob to change value. Press again to confirm value entered and move
on to the next field.
UPnP
Use this setting to set any UPnP device name. This is the name that your
music server will pickup in Media Player mode. Use the knob to keep
selecting letters of the device name by turning and pressing, and select
"END" word to confirm the name, or simply press the REPLY key.
DEVICE NAME
< END <> A BCDEFGHIJ >
DEVICE
WiFi Strength
Shows a percentage to indicate the WiFi strength.
Configure "My Stuff"
Register an account on http://rotelradio.com website
A personalized menu "My Stuff" can be setup in the top level menu.
Open the website, http://rotelradio.com, from your internet browser.
Please enter the registration key, this can be found in 'Settings > Register'
menu. Enter this registration key into the website and follow the instructions
to setup an user name and password. Remember the user name and
password, you will need this to access the site.
RT-12 DIGITAL GATEWAY