Overheat Protection; Overload Protection - Makita XML02 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Align the tongue on the battery cartridge with the

slot on the mower then slide the cartridge until it locks in

place with a little click. If you can see the red indicator

on the upper side of the button, battery cartridge is not

locked completely.

1. Battery cartridge

Insert the lock key in the place shown in the figure

as far as it will go.

1. Lock key

Close the battery cover and push it until it is

latched with the locking lever.

To remove the battery cartridge from the mower;

Slide the battery cover locking lever and open the

battery cover.

Pull out the battery cartridge from the mower while

sliding the button on the front of the cartridge.

Pull out the lock key.

Close the battery cover.

Tool / battery protection system

The tool is equipped with a tool/battery protection sys-

tem. This system automatically cuts off power to the

motor to extend tool and battery life. The tool will auto-

matically stop during operation if the tool or battery is

placed under one of the following conditions.

Overload protection

When the tool is operated in a manner that causes it to

draw an abnormally high current, the tool automatically

stops without any indication. In this situation, turn the

tool off and stop the application that caused the tool to

become overloaded. Then turn the tool on to restart.

5 ENGLISH