SMASH 16 Manual De Instrucciones página 67

PERIODICAL SERVICE POINTS
NOTE
After removing the filter, use a pinch to hold the end of the suction pipe.
When assembling the filter, take care not to allow filter fibers or dust inside the
suction pipe.
1. Cylinder fins
Dust clogging between the cylinder fins will cause
overheating of the engine. Periodically check and clean
the cylinder fins after removing the air cleaner and the
cylinder cover.
2. Fuel filter
Fuel filter
(a) Using a wire hook, take out the filter from the
filler port.
(b) Disassemble the filter and wash with gasoline,
3.Oil tank
With a wire hook, take out the oil filter through the
filler port and clean in gasoline. When putting the
Filtro
filter back into the tank, make sure that it comes to
de aceite
the front right corner. Also clean off dirt in the tank.
4. Spark plug
Clean the electrodes with a wire brush and reset the gap
to 0.65 mm as necessary.
5. Sprocket
Check for cracks and for excessive wear interfering with
the chain drive. If the wearing is found obviously, replace
it with new one. Never fit a new chain on a worn sprocket,
or a worn chain on a new sprocket.
or replace with new one if needed.
67