IKRA PCS 5046 Instrucciones De Servicio página 31

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
can damage the clutch system. When the saw chain is
caught in the cut, do not attempt to pull it out by force,
but use a wedge or a lever to open the cut.
Guard against kickback
It is extremely important that the chain brake be checked
for proper operation before each use and that the chain
be sharp in order to maintain the kickback safety level
of this saw.
Removal of the safety devices, inadequate maintenance,
or incorrect replacement of the bar or chain may increase
the risk of serious personal injury due to kickback.
Felling a tree
1. Decide the felling direction considering the wind,
Iean of the tree, location of heavy branches, ease of
job after felling, and other factors .
2. While clearing the area around the tree, arrange a
good foothold and retreat path.
3. Make a notch cut one-third of the way into the tree
on the felling side.
4. Make a felling cut from the opposite side of the notch
and at a level slightly higher than the bottom of the
notch.
WARNING
When you fell a tree, be sure to warn your neighboring
workers of the danger.
1) Notch cut
2) Felling cut
3) Felling direction
GB | Operating Instructions
This saw is also equipped with
a chain brake that will stop the
chain in the event of kickback
if operating properly. You must
check the chain brake operation
before each usage by running
the saw at full throttle for 1 or 2
seconds and pushing the front
hand guard forward. The chain
should stop immediately. If the
chain is slow to stop or does
no stop then replace the brake
band and clutch drum before
use.
Logging and limbing
WARNING
1. Always ensure your foothold as well as stability of
the tree.
2. Be alert to the rolling over of a cut log.
3. Read the instructions in "For Safe Operation" to
avoid kickback of the saw.
Before starting work, check the direction of bending force
inside the log to be cut.
Always finish cutting from the opposite side of bending
direction to prevent the guide bar from being caught in
the cutaway.
Cutting an unpillowed log
Saw down halfway, then roll the log over and cut from
the opposite side.
Cutting a pillowed log
In the area A in the picture right above, saw up from the
bottom one-third and finish by sawing down from the top.
In the area B, saw down from the top one-third and finish
by sawing up from the bottom.
Limbing a felled tree
First check which way the limb is bent. Then make a
shallow cut into the compressed side to prevent the limb
from being torn. Cut through from the tensed side.
WARNING
Be alert to the spring back of a cut limb.
11
Tabla de contenido
loading

Este manual también es adecuado para:

Pcs 4040

Tabla de contenido