IKRA PCS 5046 Instrucciones De Servicio página 29

NOTE
When restarting immediately after stopping the engine.
Set choke in the open position.
NOTE
Once the choke knob has been pulled out, it will not
return to the operating position even if you press down
on it with your finger. When you wish to return the choke
knob to the operating position, pull out the throttle lever
instead.
7. Push the front handle guard down toward the front
to activate the chain brake.
8. Decompression valve
Press the valve to reduce the pressure in the cylinder
and make starting easier. You should always use the
decompression valve when starting the machine.
Once the machine has started the valve will auto-
matically return to its orginal setting!
WARNING
Before you start the engine, make sure the saw chain is
not contacting anything. Make sure the chain brake al-
ways is activated before each starting.
9. While holding the saw unit securely on the ground,
pull the starter rope vigorously.
GB | Operating Instructions
4) Choke knob
WARNING
Do not start the engine while the chain saw hangs in
one hand. The saw chain may touch your body. This is
very dangerous.
10. When firing occur, push in the choke knob and pull
the starter again to start the engine.
11. Pull up the front handle guard toward the front hand-
le to release brake. Allow the engine to warm up with
the throttle lever pulled slightly.
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium speed
and see if chain oil is scattered off as shown in the figure.
The chain oil flow can be changed by inserting a screw-
driver in the hole on bottom of the clutch side. Adjust
according to your work conditions.
IMPORTANT
The oil tank should become nearly empty by the time fuel
is used up. Be sure to refill the oil tank every time when
refueling the saw.
Checking functional of the clutch
Before each use, you shall confirm that there is no chain
movement when the chain saw running at idling speed.
Adjusting carburetor
The carburetor on your unit has been factory adjusted,
but may require fine tuning due to change in operating
conditions. Before adjusting the carburetor, make sure
that provided are clean air/fuel filters and fresh, properly
mixed fuel.
When adjusting, take the following steps:
IMPORTANT
Be sure to adjust the carburetor with the bar chain at-
tached.
1. H and L needles are restricted within the number of
turn as shown below.
9
1) Chain oil
1) Chain oil flow
adjusting shaft
2) Rich
3) Lean