Assembly/Disassembly; Setting The Cutting Angle - Kompernaß KH2909 Instrucciones De Montaje

Assembly/Disassembly

• Place the guide piece in the saw support and then connect it to the saw arms (Fig. 7).
• Fit the saw blade and then put it under tension by tightening the wing nut on the tension bar (Figs. 8+9).
• Firmly fit the four guide rods to the saw table with the screws and washers (Fig. 10).
• Fit the spacers at the front and rear each onto one of the guide rods (Fig. 11)
• Guide the saw over the guide rods.
• Fit the carrying handle on to the top of the guide rods with the screws (Fig. 12).
To be able to use the saw without a table, the carrying handle must first be released from the guide rods (Fig. 12).
Slide the guide pieces outwards until they engage (Fig. 6).

Setting the cutting angle:

• To set a cutting angle of 36°, for example, count to the right or left of the 90° line 90°-36°=54°. Obtain the lock position of 54° on the saw table by
lifting the lever on the cross beam upwards and then releasing it after turning the saw to the position 54°. The cross beam then locks into this position.
• To adjust to an angle of inclination, if necessary loosen the securing screws at the front and rear ends of the cross beam (Fig.3). Then pull the latching bolts
down and incline the saw until until the bolts engage in the next position..
a
s
u
d
- 7 -
i
o