Sears Kenmore 363 Manual De Uso Y Cuidado página 31

ICEMAKER IS NOT PRODUCING ICE
Check if... Then.,.
The icemaker feeler arm is up in the STOP (up) Lower arm to ON (down) position_
position,,
The freezer is not cold enough to produce ice,, Allow 24 hours after the refrigerator is installed for the
icemaker to begin producing ice.
The water supply shutoff valve is turned off. Check the water supply connection in your house and turn
disconnected or the water tubing is clogged, on the water supply if necessary. Unclog tubing.
The icemaker mold has no water in it. The water supply is incorrectly installed or not connected.
See Water Line Installation Instructions,, Use only copper
tubing. Do not use piercing-type valves,
The water pressure seems too low or too high° The icemaker needs to be connected to a cold water line
with water pressure between 20 and 120 ps.L on models
without a water filter and between 40 and t20 p.,sJoon
: models with a water filter.
Supply line is clogged Call a plumber
Shutoff valve is not turned on. Turn on shutoff valve
SMALL OR HOLLOW CUBES
Check if,.. Then...
I Water filter is clogged I Replace cartridge or remove plug., /
filter filter and install
WATER IS SPURTING FROM DISPENSER
Check if.,. Then...
Newly-installed filter, Run water from the dispenser for two minutes [about one /
gallon (3_8 liters)].
J
WATER IN FIRST GLASS IS WARM
Check if... Then...
The refrigerator was recently plugged in and Allow about 24 hours for water to cool to proper
the temperature controls were set. temperature.
Water dispenser has not been used for an Water in first glass will not be as cooi as in succeeding
extended period, glasses_
Water system has been drained. Allow several hours for replenished supply to get cold.
ORANGE GLOW IN FREEZER
Check if... Then.,.
I Defrost heater is on. 't' Refrigerator is operating normally f
31