Start Up; Final Checks; User Instruction - Erreka ABC2M-009 Manual Del Instalador

ABC2M-009_ES_FR_EN_PT_DE.book Page 52 Thursday, April 17, 2008 9:43 AM
PROGRAMMING AND STARTING UP
Torque (P.M1 and P.M2) and speed (V.M) adjustment
F < 400N in spaces between 50mm and 500mm
d
F < 1400N in spaces> 500mm
d
8

START UP

Final checks

Following installation and programming, start up the
operator with all the devices you have installed.
1 Check the correct operation of the control devices
(push button and wall key, remote control).

See "Closing modes" on page 41.
2 Check the correct operation of the safety devices
(photocells and strips).

See "A- Detection by the additional safety device
(photocell or safety strip)" on page 42.
3 Place an obstacle and make the gate meet it in order
to check operation in the event of collision.

See "B- Direct detection (sensibility of the
operator)" on page 42.
4 If everything is correct, close the control panel cover.

If the system does not work correctly, find out
why and put it right.
52
Installation manual

The correct adjustment of the torque and of the
speed is of vital importance for the gate to stop
automatically when coming across a possible
obstacle without producing any injury or
damage. Any increase in the torque and in the
speed will produce a more violent impact.
1 Regulate the torque (force) potentiometers (P.M1 for
M1 and P.M2 for M2) at the minimum possible value,
compatible for good operation of the gate.
2 Regulate the required speed using V.M.
3 Check the force of the impact and compare with the
values shown in Standard EN12453:2000. If the
values measured are greater than those of the
standard, reduce the speed or the torque.

The torque and speed regulator of the control panel
must be adjusted in a manner which respects the
values indicated in standard EN 12453:2000, as
shown in the attached chart. The measurements
must be made in line with the method described in
standard EN 12445:2000.

User instruction

1 Instruct the user with regards to the use and
maintenance of the facility and provide him/her with
the use manual.
2 Point to the gate, showing that it opens
automatically, and indicating how to operate it
manually. Where appropriate,
operation is using the remote control.
indicate that