Tabla de contenido
Idiomas disponibles
Idiomas disponibles
VM9510TS
TV TUNER OPERATION
Accessing TV Mode
To switch to TV mode, press the SRC button (8) on the
remote control or front panel until TV appears at the bottom
of the screen.
NOTE: Touch the top left corner to access the MAIN
MENU Multi-ZONE SETUP menu and the top right corner
to access the Multi-ZONE menu (rear zone setup).
Auto Tuning
Press the
button (19) on remote control, or the
on the joystick (17) to seek the next available TV station by
increasing the tuning frequency.
Press the
button (17) on the remote control, or the
button on the joystick (16) to seek the next available TV
station by decreasing the tuning frequency.
Press the
/BAND,
,
,
or
button to stop
searching.
Once a TV station is searched, the auto seeking stops and
the TV station is played. If no station is searched, the tuning
stops at the first channel after performing a round search.
Manual Tuning
Press the
or
buttons (16, 17) on the joystick to increase
or decrease the TV frequency one step.
Storing Stations (AS)
Automatic Preset Memory
To select the strong stations in the current TV frequency
range, press and hold the joystick button (20) to activate the
Auto Store function. The new stations replace stations
already stored. Press the joystick button again or press the
/BAND button (20) on the remote control to stop searching.
Using Preset Scan
To scan stored stations:
1.
Press the joystick button (20) to scan all stored TV sta-
tions. The unit pauses for 10 seconds at each station.
2.
Press the joystick button again or press the
button (20) on the remote control to stop scanning and
play the current station.
Selecting a TV Station
To browse through stored stations:
•
Press the
button (15) on the remote control, the
button (19) on the joystick or the CH- button on the front
panel to tune the previous stored station.
•
Press the
button (22) on the remote control, the
button (18) on the joystick, or the CH+ button on the
front panel to tune the next stored station.
Direct Channel Selection
Use the numeric keypad on the
remote control (29) to enter a
specific TV station.
Display Current Channel
Press the DISP button (10) on the
remote control to display
button
information regarding the current
TV station.
/BAND
23
Tabla de contenido
Solución de problemas
