Brandt BFC582LNW Guia De Instalacion página 32

It may not work properly If left at a
temperature above or below the
indicated range for a long period of
time.
Climate class Ambient
temperature
SN +10°Cto+32°C
N +16°Cto+32'
ST +16°Cto+38°C
T +16"Cto+43°C
• Place your appliance in a dry place to
avoid high moisture.
• Keep the appliance out of direct
sunlight, rain or frost. Keep the
appliance away from heat sources such
as stoves, fires or heaters.
Leveling of appliance
• For the appliance to be sufficiently
leveled, and the air to circulate
correctly in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
• To allow the doors to self-close, tilt
the top backwards by about 10mm.
^lO mm
Reversing the door
The side at which the door opens can
be changed, from the right side (as
supplied) to the left side, if the
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need
8mm socket wrench
Thin-blade screwdriver
Note: Before you start, lay the
, C
refrigerator on its back in order to gain
access to the base. You should rest it
on soft foam packaging or similar
material to avoid
backboard of the refrigerator. To
reverse the door, the following steps
are generally recommended.
1. Stand the refrigerator upright. Open
the upper door to take out all door
racks (to avoid damaging the racks)
and then close the door.
2. Lift part ① from the top of the
refrigerator body from the right side
and then take down part ③ and part④
of the upper door in the same way.
Take down part ② and put it back into
the plastic bag.
10
Cross-shaped screwdriver
8mm wrench
damaging the