AEG RMB96716CX Manual Del Usuario página 13

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 200
3. Continue dispensing water for about
four minutes to flush the system
and plumbing connections of any
impurities (stopping to empty the
glass as necessary).
Dispenser
NOTE
The water dispenser has a
built-in device that shuts off the
water flow after three minutes
of continuous use. To reset this
shutoff device, simply release
the dispenser paddle.
NOTE
After the initial 750 ml, water will
remain room temperature until
the tank has refilled and been
given enough time to chill the
next 750 ml of water. May take
up to 8 hours to chill.
7.3 Ice maker operation & care
After the refrigerator is installed properly
and has cooled for several hours, the ice
maker can produce ice within 24 hours.
The ice maker will fill the ice bin from the
rear. Dispense some ice to force the ice
forward in the bin. This will allow the bin
to fill completely.
7.4 Ice Maker and Storage Bin
Capacity
This ice maker should produce 1 Kilogram
of ice per 24 hours. The ice bin will hold
about 1,6 Kilogram of ice.
7.5 Turning the fresh food
ice maker on and off
IMPORTANT
The ice maker is turned on at the
factory so it can work as soon as
the refrigerator is installed. If it is
not possible to connect a water
supply, set the ice maker's On/
Off feature to Off; otherwise, the
ice maker's fill valve may make
a loud chattering noise when it
attempts to operate without water.
Ice production is controlled by the ice
maker's On/Off feature on the control
panel. Pressing the On/Off feature turns
the ice maker on & off.
NOTE
The ice maker also has a
built-in plastic signal arm that
automatically stops ice production
when the ice bin is full. This
signal arm should not be used
to manually stop the ice maker.
IMPORTANT
Turning off the ice maker simply
disables ice making. Existing ice
can still be dispensed, and water
can be dispensed.
IMPORTANT
On occasion, unusually small
ice cubes may be noticed in the
bucket or in dispensed ice. This
could occur in normal operation
of the ice maker. If happening
frequently, it may be an indication
of low water pressure or the
water filter needs to be replaced.
As the water filter nears the end
of its useful life and becomes
clogged with particles, less water
is delivered to the ice maker
during each cycle. Remember,
if it's been six months or longer
since last changing the water
filter, replace it with a new one.
Poor quality household water
may require the filter to be
changed more frequently.
CAUTION
If the water supply to the
refrigerator is softened,
be sure the softener is properly
maintained. Chemicals from a
ENGLISH
13
Tabla de contenido
loading

Este manual también es adecuado para:

Rmb96726vx

Tabla de contenido