Cutting Tool; Preparations At The Workplace - Hilti NCT IS 025-A22 Manual Del Usaurio

Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the LEDs of the charge state indicator flash, follow the instructions
in the 'Troubleshooting' section.
3.5 Items supplied
Cutting tool, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group | USA: www.hilti.com
4

Cutting tool

Rated voltage
Weight
Max. cable diameter
Max. cutting capacity
4.1 Battery
Battery operating voltage
Ambient temperature
Storage temperature
5 Operation
5.1

Preparations at the workplace

CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Inserting the battery
CAUTION
Risk of injury! A falling battery presents a risk of injury.
▶ Take care to ensure that the battery is inserted correctly.
1. Push the battery into the product's battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
2188460
*2188460*
Printed: 13.06.2018 | Doc-Nr: PUB / 5365807 / 000 / 02
2
3
NCT IS 025-A22
21.6 V
3.4 kg
(7.5 lb)
25 mm
(1.0 in)
• 557 kcmil ACSR (Eagle), 3/8"
guy wire (EHS)
• Cu/Al cable, 1" (25 mm)
outside diameter
21.6 V
−10 ℃ ... 60 ℃
(14 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
English 5