Other Functions; Touch Control Settings; Transpose; Function Mode - Korg D1 Manual Del Usuario

Touch control settings

The keyboard sensitivity, or touch, can be programmed.
To change the setting, hold down the TOUCH button and
press the + or – button beside the display.
Display Touch control settings
001 Light. Loud notes can be produced even by playing
lightly.
002 Normal. Normal piano touch.
003 Heavy. Loud notes can be produced only by play-
ing very hard.
004 Stable. Sensitivity variations are reduced, and a
relatively stable sound is produced.
005 Steady. Steady notes are produced, like with an
organ, regardless of the force used to press the key.
When the instrument is turned on, the touch setting is
reset to 002 (Normal).
The settings are applied to all sounds.

Transpose

In some cases, a song may be written in a difficult key (e.g.,
many black keys), or you may wish to shift the pitch to
match another instrument or vocalist. In such cases, you
can transpose (shift the pitch) so that you can use an easier
fingering, or use the same familiar fingering to play at a
different pitch. This is called the Transpose function.
You can shift within a range of 11 semitones so that when
transposing upward by one semitone, playing the notes
shown at the left produces the pitches shown at the right.
When the instrument is turned on, the transposing is
reset.
While holding down the TRANSPOSE button, press the
keyboard key (F#6–F7) for the desired transposition.
If a keyboard key other than C7 is pressed, the TRANS-
POSE button lights up to indicate that the keyboard is
transposed.
The pitch of the entire keyboard is transposed according
to the pitch of the pressed keyboard key in relation to C7.
To return to the original pitches, hold down the TRANS-
POSE button and press the C7 key. The TRANSPOSE but-
ton turns off, and transposition is canceled.

Other functions

Loud
004
001
005
002
003
Quiet
Playing
Quiet Loud
strength
C4
key Effect
#
F 6–B6 6–1 semitones below
C7 Standard pitch
#
C 7–F7 1–5 semitones higher

Function mode

The temperament as well as other pitch settings can be
specified from the Function mode.
Setting procedure for functions in the Function
mode
1. Press the FUNCTION button.
The FUNCTION and PIANO1 buttons light up.
2. Press the appropriate button shown below to select a
parameter.
The pressed button lights up, and the current setting
appears in the display.
Volume balance of layer mode
Octave of layer mode
Temperament
Pitch
Auto power-off
3. Press the + or – button to select a setting.
Pressing the + and – buttons simultaneously, the fol-
lowing settings can be restored to the default settings.
• Pitch
• Volume balance of layer mode
• Octave of layer mode
4. After specifying the desired settings, press the
FUNCTION button to return to the mode for playing.
The FUNCTION button turns off.
When the D1 is turned off, all functions, except the
auto power-off function, return to their default set-
tings.
F 6
C7 F7
Pedal of layer mode
11