Adding The Mounting Holes - Avigilon 1.0-H3M-D01 Guia De Instalacion

Adding the Mounting Holes

The holes needed to mount the HD Micro Dome camera are very
close together so it is important to complete the following steps in
order to maintain the integrity of the mounting surface.
1. Make sure the arrow on the mounting template points in
the direction that the camera will face then attach the
template to the mounting surface.
2. Mark the centers of the mounting holes through the
mounting template and onto the mounting surface.
You only need to mark the larger hole if you plan to store
the cable assembly inside the wall.
3. Drill the two smaller holes (A).
•
•
•
4. If you plan to store the cable assembly inside the wall, drill
the larger 31.75mm (1.25") hole (B) with a hole saw.
NOTE: If the area behind the mounting surface is prone to water and
dust, make sure the provided rubber boot is used to protect the
camera's PoE connection.
4
If mounting on drywall, use a 3/16" diameter drill bit
and install the supplied inserts.
If mounting on wood, make a pilot hole for #4 wood
screws.
If mounting on any other surface, drill a hole that is
appropriate for the chosen mounting surface and
mounting hardware. Do not use screws larger than
a #4 screw.