Before Use; Getting Started - WMF Lumero Instrucciones De Uso

Before use

The espresso machine may only be used for its intended purpose in accordance with this instruction
manual. You are therefore advised to read the instruction manual carefully before use, as it provides
instructions for using, cleaning and looking after the device. We accept no liability for any damage
caused if the instructions in this manual are not followed. Keep the instruction manual in a safe
place and pass it on to any subsequent user together with the device. Please also note the warranty
information at the end of the instruction manual.
The safety precautions must be observed during use.
Technical data
Rated voltage: 220-240 V~ 50-60 Hz
Power consumption: 1400 W
Protection class: I
Additional safety information
▪ The device should be connected only to earthed wall sockets that have been installed in accordance
with the regulations. The power cable and plug must be dry.
▪ Do not pull or clamp the connection cable over sharp edges. Do not leave it dangling. Protect it
from heat and oil.
▪ Only use an extension cable if it is in perfect condition.
▪ Never pull the mains plug out of the socket by the cable, always use the plug, and never disconnect
or touch the plug with wet hands.
▪ Do not carry the appliance by the cable.
▪ Do not place the espresso machine on hot surfaces, such as hotplates or the like, or near open gas
flames, as the casing could melt.
▪ Do not place the appliance on water-sensitive surfaces. Splashes of water may damage such
surfaces.
▪ Do not switch the device on without water. Fill the water tank with cold water no higher than the
MAX marker.
▪ If the device will not be used for a longer period of time, pull the mains plug out of the socket.
▪ Stop using the device and/or pull the mains plug out of the socket immediately if:
⋅ The device or power cord is damaged
⋅ The device is leaking
⋅
You suspect that the device may be defective after being dropped or a similar incident.
In such cases, take the device to a specialist workshop to be repaired.
▪ Only operate the device under supervision.
▪ Children should be supervised in order to ensure that they do not play with the appliance.
▪ Descale the device regularly.
▪ We do not accept any liability for damage caused as a result of misuse, incorrect operation,
improper repair or failure to observe the descaling instructions. Warranty claims shall likewise be
excluded in such cases.
▪ Packaging materials, such as plastic bags, must be kept out of the reach of children.
22
Handy tips
We recommend using freshly roasted coffee in accordance with your personal preferences. Ask your
local coffee retailer for advice. Once it is roasted, coffee does not remain fresh for very long. You can
improve the shelf life of your coffee by packaging it well and storing it in the fridge.
Use fresh water; do not leave the water in the device unused for more than 4 days.
Empty and rinse the water tank regularly (once a week). Always switch the device off before removing
the tank for filling or emptying. Always place the device on a flat, stable surface.
Tips on selecting coffee types
Full aroma:
It is best to choose coffees made from pure Arabica beans or those made primarily from Arabica beans.
Hand-roasted coffees are better because they have more complex and finer aromas. For a change of
flavour, try single-origin coffees.
Strong coffee:
Use coffee blends with Robusta beans – those which are not specified as 100% Arabica – or coffee
described as "Italian Roast" or "Italian Coffee".
Fill the portafilter to the top with coffee powder and use the tamper to press the powder down.

Getting started

Before using for the first time, clean all the accessories with warm water and gentle dishwashing
liquid and dry.
Then rinse as follows:
1. Connect the device to a mains socket.
2. Take off the lid (A) and remove the water tank (B).
3. Fill the water tank no higher than the MAX marker and place it in the device. The tank must be
correctly positioned. Replace the lid.
4. Make sure the selector switch (G) is set to the O position (G3 ->
5. Press the On/Off button (L -> ) to switch the device on. The device runs self-diagnostics.
6. The cup selection buttons (D1/D2 ->
When the light rings go from red to white, the device is ready to use.
7. Place a receptacle with a capacity of at least 100 ml underneath the steam outlet (H).
8. Adjust the hot water output knob (G4 -> ) and allow approx. 100 ml water to run out; then reset
the knob to G3 = .
9. Then prepare 1–2 espressos or 1–2 cappuccinos. Do not drink them.
Perform steps 1–7 in the "Making espresso" section.
).
) light up red to indicate that the device is heating up.
23