Load Handling Instructions; General; Attachments; Environment - BRIGHT Coop BC3 6560 Manual Del Operador

Tabla de contenido

Idiomas disponibles

General

1. Do not attempt to perform any operation which exceeds the capacities of your lift truck or attachment.

2. Before lifting a load: check the size, weight, and condition of the load.

3. If the load is not properly marked, check with your supervisor for verification of weight. Divide the load into

smaller unit if necessary.

4. Note the center of gravity of the load area where to place the forks for stable transport.

5. Verify that the load is properly wrapped or banded and safe to transport. Check the condition of the pallet or

skid. Does it need to be replaced? If the load is of loose materials or is poorly wrapped, it must be made secure.

6. Secure the load so that it will not shift or fall during transport.

7. It is prohibited to increase the counterweight value in any way.

8. It is strictly prohibited to carry or to lift personnel with the forklift.

9. Never lift a load with a single fork.

10. Never lift a sling load with a single fork or with the carriage.

Attachments

1. Ensure your lift truck's attachments function correctly.

2. Ensure that the attachment is correctly fitted and locked to its frame.

3. Adhere to the limits on the load chart for the lift truck and/or attachments.

4. Ensure that quick fit hydraulic connections on the attachment system are clean and protected.

Environment

1. Take care when raising a load that no object or person is in the way of mast or forklift movement.

2. In the case of work near aerial lines, ensure that the safety distance is sufficient between the working area of

the lift truck and the aerial line.

3. Do not allow personnel to come near the working area of the lift truck or pass beneath an elevated load.

4. When using the lift truck on a slope, before raising the forks ensure that the forklift is level and stable

5. Ensure that the loading platform or pile is capable of bearing the weight.

6. Ensure the stability and solidity of the ground before depositing the load.

7. When traveling on a longitudinal slope drive and brake gently. Move with load / forks facing uphill.

Handling

1. Always consider safety. Only transport balanced and correctly secured loads to avoid any risk of tipping.

2. Fully engage forks under the load and transport in the low position approximately 12" (300mm) from the ground,

with the mast retracted to the maximum and sloping backwards.

3. Do not maneuver the forklift with the mast in the raised position except under exceptional circumstances and

then only with extreme caution, at very low speed and using gentle braking. Ensure that visibility is adequate

and get another person to guide you along if necessary.

4. Never shift the position of the load while the lift truck is in motion.

5. The simultaneous use of two forklifts to handle heavy or bulky loads is a dangerous maneuver, requiring spe-

cific precautions to be taken. This should only be done in exceptional circumstances and in the presence of a

handling manager.

6. Never drive too fast or brake abruptly when carrying a load.

Bright Forklift

BC3–6560