Adjust Between Blades - Merand AQUAPAN 75 Manual De Instrucciones

To change the product it's necessary to change de axis of the slicers of the
longitudinal cut. The procedure is the following:
A B
Take out the machine press to reach the cut support.
Lift the lever until the extremes of the axis of the slicers come out of the side
fixation.
Now we have the screws free so that we can take them off, or change them
for another axis for a new product.
The process for assembly is the same but the opposite way

23.2.4. ADJUST BETWEEN BLADES

Release the blades of the axis loosening the screws of the prisoner's screws
B..
Move the blades to their new position, and tighten again the prisoner's
screws.
IMPORTANT: Never execute this operation with the blades on the machine.
Page 52
H.BERDER 10/04/2012