How To Assemble Your Sprayer; Operation; Maintenance - Swissmex Advanced Serie Manual De Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

3.3.2 How to assemble your sprayer:

Following is explained how to assemble your sprayer, read carefully the text. The number at the beginning of the line corresponds to the
graphic.
1. Place the sprayer vertically on a table and loosen the nut and slide the pump tube out a little, place the agitator in the pump tube and tighten the nut.
2. Place the strainer and the tank lid on the tank opening.
3. Insert the connecting rod in the pump tube placing one flat washer on each side, fix them with the lock pins "C".
4. Pass the pump handle through the base of the tank fixing it to the connecting rod with a flat washer and a lock pin "C" and on the other end with a lock
washer and a cotter pin.
5. Finally tighten the spray gun and tube.
1
3
4
4

OPERATION

4.
Always use the strainer when filling the tank up with liquid.
Mix the solution in a separate container, following the supplier directions on the box.
Pour pre-mixed solution into sprayer and cap.
Place the sprayer on your back and pressurize tank by pumping 25 times approx.
You will need to pump once each 3 or 4 seconds to maintain the desired spraying pressure.
For a continuous spraying, fix the shut-off valve lever with the lever lock.
Move the nozzle cap to change the spraying pattern.
The use of agrochemicals is dangerous, it should be operated with care.
5.

MAINTENANCE

Since the sprayer needs little maintenance, if you follow the steps mentioned in this manual its lifespan will be very long.
Do not keep the sprayer with pressure after finishing your spraying job, release the pressure through the nozzle depressing the trigger, then take the
cap and strainer out and pour the remaining solution. Now rinse system with fresh water as follows:
Pour approximately 1/2 gallon of fresh water in the tank, pressurize and flush, the pumping system by pressing trigger at least 2 minutes, then
drain all remaining water.
Carrying straps are made of non-absorbent materials, nevertheless in case of solution spillage, wash them with fresh water to eliminate all risk
of skin irritation.
2
5
3
NOTE:
To ensure good performance use original
"SWISSMEX-RAPID" spare parts.

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

326195 sp11

Tabla de contenido