Tabla de contenido
Idiomas disponibles
Idiomas disponibles
AIR FAN
4. Plug the machine on the power supply and turn it on.
5. Press L
Air fan will turn on automatically when positioning the hands inside UV dryer.
When removing hands from within unit, the fan will stop
6. Press L
Caution
5. When inserting hand inside the unit, please make sure costumer does not contact UV
lamps directly, make sure hands are on reflector.
6. Hands should be placed on proper position so as to be detected by infrared detector,
to switch on UV lamp. Please refer to picture 7.
7. Do not use this unit to dry any flammable solvents, such as polish remover.
8. Please switch off machine after operation.
Nail Driller and Dust Collector
NAIL DRILLER
5. Connect machine to the power supply, and then switch the power on.
6. Insert the connector of driller into the O socket of rear panel (picture 6).
7. Press P
Driller speed can be adjusted from 1 to 10, by means of pressing D/F
Refer to I LED display to see the speed level activated.
8. Rotating direction can be modified by pressing G
Driller head exchange
2. To disassemble and assemble the head, please rotate the driller head on direction
as per picture below
back on the fixing head position
Note: before turning on the rotative driller, please make sure the "S" point is next
to red dot, which means that the head is totally fixed to the driller.
, then LED A will light up, and fan will be on standby.
to switch UV dryer fan off.
to activate the driller. Press again P
(picture 9)
Picture 7
. Proceed in reverse order to fix the rotative head
(picture 8
), where "S" is facing the red dot.
.
to turn this function off.
when driller is on.
.
Tabla de contenido
