Rear Panel; Front Panel - Marq Gesture Spot 300 Guía De Usuario

Ocultar thumbs Ver también para Gesture Spot 300:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Features

Rear Panel

1. Power In: Use a standard power cable
(included) to connect this input to a
power outlet.
2. Fuse: This compartment holds the fuse.
Before cleaning or replacing the fuse,
disconnect Gesture Spot 300 from its
power source. Use a screwdriver or
other tool to remove the compartment
(do not pull it out by the tab only).
Replace the fuse only with a new fuse
with the same rating (250 V, 4 A).
3. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)
to another fixture that will pass DMX data through it to this one. Gesture Spot 300 receives DMX
data over this connection. Please see
multiple fixtures.
4. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture.
Gesture Spot 300 sends its data to an additional fixture over this connection. Please see
Linking > DMX

Front Panel

5. Display: This display shows messages and
values indicating the fixture's current status.
6. Menu: Press this button to access Gesture
Spot 300's menu.
7. Up: Press this button to select the next-
highest menu option or to increase the
value by 1.
8. Down: Press this button to select the
next-lowest menu option or to decrease
the value by 1.
9. Enter: Press this to confirm your current selection or value.
10. DMX: This light will illuminate when Gesture Spot 300 is receiving DMX data properly through its
DMX In.
11. Error: This light will illuminate when Gesture Spot 300 receives an invalid DMX command.
4
for information about linking multiple fixtures.
1
2
Setup > Linking > DMX
3 4
for information about linking
10
5
11
6 7 8 9
Setup >
Tabla de contenido
loading

Tabla de contenido