P9R Bodypack Receiver
Bodypack Receiver
① Power Switch and Volume Control Turns the bodypack on and off
and adjusts earphone volume.
② 3.5 mm Earphone Jack Insert earphones here.
③ Scan Button Press the scan button to find an available frequency.
Press and hold for two seconds to find the group with the most available
channels.
④ IR Window For transmitting settings between bodypack and rack unit.
⑤ Battery Compartment Requires 2 AA batteries. Open by pressing the
latches on both sides and pulling.
⑥ Menu buttons Use in conjunction with the ▼▲ buttons to access the
configuration menus.
⑦ ▼▲ Buttons Use to adjust the audio mix (in MixMode only), or in
conjunction with the menu buttons to change settings.
⑧ LCD Screen Displays current settings and menus.
⑨ Tri-Color Battery LED illuminates green, orange, red, or flashing
red, to indicate battery power. When flashing red, change batteries
immediately.
⑩ Blue RF LED Indicates the bodypack is receiving a signal from the
transmitter.
⑪ Detachable Antenna SMA Connector
Battery Indicator
Tri-Color Battery
LED
Green
Green
Green
Green
Orange
Red
4
Approximate Hours
Remaining
Alkaline
NiMH (2450
mAh)
5–7
4
3½–4
3–3½
3–3½
1½–2
2–2½
⅕
½–1
0
⅕–½
0
RF Settings
RADIO
G
Sets the group number
CH
Sets the channel number
888.888MHz
Manual frequency selection
Audio Settings
AUDIO
MODE
Selects monitor mode
STEREO
MIXMODE
HIBOOST
High-frequency EQ boost
OFF
4 dB
2 dB
V LIMIT
ON
VALUE
BAL ST / BAL MX
Left and right balance for earphones when in stereo
mode, or mix of left and right channel for MixMode
Utilities and Display Settings
UTILITIES
CUEMODE
Enters CueMode (to exit, press enter and select
EXIT CUEMODE)
DISPLAY
Changes the display format
CONTRAST
Changes the display contrast
LOCK PANEL
Locks all controls except power and volume. To un-
lock, press exit, select OFF, and press enter.
Stereo
MixMode
flat
+4 dB @ 10 kHz
+2 dB @ 10 kHz
Limits volume level
3–9: analogous to volume
knob position (for example, 5
is equal to the 5th dot on the
volume knob)