Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DMP808
If your DMP808 and your computer are connected through an existing local area network and not a set IP address,
please follow the steps below to establish a connection�
1� Make sure that your DMP808 and computer have
successfully connected to the local area network�
2. Select the executable file (.exe) inside the DMP808
Control Software folder�
3� Select
at the login screen to search the current
IP address�
4� All the existing IP addresses will appear in the "Device
IP" drop-down box�
DSP
The DSP page will give you an overall idea of input and output mixes (including levels and naming) as well as offer a
manner to view and edit the current signal processors assigned to input and output channels�
Name: Edit the name for each of the individual input
channels�
On/Off: Use this button to switch the corresponding input
channel on and off�
Processing: These buttons allow you to inject any of the
DMP808's internal signal processors right into the input
chain� Processing will be accomplished in order from left
to right� For more information on the available programs,
check the Signal Processor section of this manual
Reset Button: Pushing these buttons will reset the DSP
parameters for the input or output, including name, on/off
status, and selected signal processors� There is a reset
button available for each the input and output�
Monitoring: The DMP808 software offers extensive
monitoring for DSP performance� The percentage of the
processor used will be visible at the bottom of the page�
English
5� Select the IP address that will be used for DMP808�
6� Enter the following information on the login page�
User Name: USER_1
Password: ASYSTEMS
7� Click
to begin the installation�
8
Capítulos
Tabla de contenido
Solución de problemas
