System Information - TECshow HALO 1R Manual De Usuario

Invert Tilt
Pan-Tilt Swap
No DMX Signal
Display
Lamp on @
start up
Linear Color
Load Defaut
Manual control interface
This interface use for control present light, And
then auto enter into master mode (didn't received
DMX signal, sent the dmx signal to slave light)
Manual menu will according to standard 13Channel
to set menu.
Option
1CH. Pan
......
11CH. Shutter/Strobe
12CH. Lamp power/Reset

System information

Option
Ver
DMX Monitor
OFF
ON
OFF
ON Change the channel of Pan-Tilt axis (include Pan-Tilt Fine)
KEEP According to the original state continues to run.
CLEAR Motor reset, stop running.
ON Closing backlight after free 30 seconds.
OFF Backlight still lighting.
OFF Reset directly after Power on , lamp off (need to use the menu or control
table to manual let lamp light)
ON Lamp light directly after power on, And must wait for the lamp light up
success then reset.
ON Color wheel linear change.
OFF
Press ok key see the confirmation dialog box, Press OK key to restore to
default set.
0~255 Press OK key into edit state, Then selected hundreds place.
Press up or down, change address code. Press OK key again,
0~255
selected ten place and edit. Press OK key again, select the first
0~255
place and edit. Press it to exit the edit state.
Press ok key see the confirmation dialog box, Press OK key to
reset surface, all motors reset.
Current software version: A101
Enter into sub-surface, using value and percentage show the DMX channel to
check.
Instruction
Instruction
P. 5
| Tecshow Halo 17
English version