If Something Does Not Work; Electrical Connection - Teka GF-1 Manual De Instrucciones

Installation
The lower part of the extractor must be
located at a minimum height of 60 cm
above the hob for electric cookers and 65
cm for gas cookers. If the instructions of
a gas cooker indicate a greater distance
these must be observed.
The extractor must be connected to a
wall socket with an effective earth.
When the extractor is working at the
same time as other non-electrical cook-
ing equipment, the outlet air pressure
must not exceed 4 Pa (4 x 10 -5 bar).
To achieve optimum performance the
length of the outlet hose should not
exceed 4 meters, or include more than
two 90º angles (elbows).
Although venting to the outside is recom-
mended, activated carbon filters may be
used, which allow the gas to be returned
to the kitchen through the outlet pipe.

If something does not work

Before seeking technical assistance car-
ry out the following checks first:
Defect
The extractor The cable is not connected
does not work No current is reaching the plug
The extractor does not Filter saturated with grease
blow enough or vibrates
Inadequate air conduit
The lamps do not light
18
Fitting in Kitchen Unit
This hood is already fitted with two fixing
devices:
1 By means of the wood-screws provid-
ed in the accessory bag, the hood is
fixed to a wooden panel in which the
fixing hole has already been cut.
2 By means of a wooden panel in the
upper part of the hood, which has pre-
viously been drilled to allow the fume
exhaust chimney to pass as well as
the mains cable and the fixing screws
(illustration page 20).
Possible cause Solution
Connect the mains cable
Revise/repair the
electricity circuit
Clean or substitute filter
Outlet obstructed Eliminate obstructions
Contact the installer and follow
instructions of this manual
Lamp broken Exchange the bulb
Lamp loose Tighten bulb
Special U.K. Requirements
Height above gas hob: 75 mm minimum
NEVER PLACE THE COOKER HOOD OVER
AN EYE-LEVEL GRILL.
This appliance must be connected by a
competent person, using fixed wiring via
a DOUBLE POLE SWITCHED FUSED
292
SPUR OUTLET.

Electrical connection

We recommend that the appliance is con-
nected by a qualified electrician, who is a
member of the N.I.C.E.I.C. and who will
comply with the I.E.E. and local regulations.
Should the colour of the wires in the mains
lead for the appliance not correspond with
the coloured markings identifying the termi-
nal in your spur box proceed as follows:
- The wire which is coloured blur must be
connected to the marked N (Neutral) or
coloured Black.
- The wire which is coloured brown must be
connected to the marked L (Live) or
couloured Red.
- Where avialable (see installation), the wire
which is coloured yellow/green must be
connected to the market or coloured
Yellow/Green.
If the cooker hood is installed for use
above a gas appliance then the provision
for ventilation must be in accordance with
the Gas Safety (Installation & Use) Regula-
tions 1984 and the relevant Building Reg-
ulations. Detailed recommendations are
contained in the following British Standard
Codes of Practice BS6172, BS5440 and
BS6891 Current Edition.
19