Installation - AKO 55323 Manual De Usuario

5532H301 Ed.01

4.- Installation

- Remove the bezels (1) from the unit.
- Loosen the screws (2) by turning them a 1/4 turn and open the cover (3).
- Drill the holes needed for the cable entry glands using the pre-stamped centres on the sides of the housing for
guidance. Fix the glands onto the device (4 and 5).
- Make the 3 holes in the wall using template included.
- Fix the unit to the wall using the screws and plugs supplied (6).
- Insert the cables into the glands. Wire the unit following the diagram on page. 14.
- Connect the battery (7) before closing the cover.
- Close the cover (3), insert and tighten the screws (2) and replace the bezels (1).
1
2
Max. M20
5
3
6
7
4
Max. M25
13