Using Controlpro - Pentair ControlPro CPRO-1010 Guia De Instalacion

Using ControlPro
General
All configuration and operation of the ControlPro is done using the 4 keys on the Control Unit. These keys will allow
you to navigate the ControlPro menu structure and modify user parameters.
Key
"UP / PLUS"
Allows moving further in a menu or increase a value
"DOWN / MINUS" referred to as
Allows moving back in a menu or decrease a value
"ENTER / OK" referred to as
Validates a menu option or value
"ESCAPE/ BACK" referred to as
Allows returning into the menu or continue operation without
validation of a value
Display
The 2 x 16 character LCD display will indicate actual time, water temperature and the status of heating and filtration
(alternating).
At the same time special symbols represent the status of each input and output. Their meaning is explained below.
"Communication with Interface Module established" (should always be displayed. If not check the
connections)
"Pool cover Closed". This symbol will blink when filtration is running because it is linked to the pool cover
open position (see configuration menu)
"Dosing output is active"
"Filtration output is active". When using a multispeed pump the active pump speed (1 to 4) is also
displayed.
"Solar Output active"; the symbol will blink in case the solar output is driving the filtration.
"Heater output active". The symbol will blink if the heater output is driving the filtration.
"Antifreeze mode active". The symbol will blink if the antifreeze output is driving the filtration
"Low temperature": whenever this symbol is displayed the 'dosing' output is made inactive because the
pool temperature is too low (see configuration menu)
12 ControlPro
Description
+
referred to as further in the text
-
ENT
ESC
further in the text
further in the text
further in the text