General Power Tool Safety Warnings; Impact Driver Safety Warnings - Makita TD0101 Manual De Instrucciones

ENGLISH (Original instructions)
1. Switch trigger
2. Lamp
3. Reversing switch lever
4. Bit
5. Sleeve
6. Bit-piece
7. Standard bolt
SPECIFICATIONS
Capacities
No load speed (min
Impacts per minute (min
Max. fastening torque
Dimensions (L x W x H)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
8. Fastening torque
9. Fastening time (S)
10. Proper fastening torque
11. High tensile bolt
12. Limit mark
13. Screwdriver
14. Brush holder cap
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
-1
)
Net weight
Safety class
IMPACT DRIVER SAFETY
ENE033-1
WARNINGS
1. Hold the power tool by insulated gripping
ENF002-2
surfaces, when performing an operation where the
fastener may contact hidden wiring or its own
cord. Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and could
give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
GEA010-2
4. Wear ear protectors.
5. Do not touch the bit or the workpiece immediately
after operation. They may be extremely hot and
could burn your skin.
6. Keep hands away from rotating parts.
7. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
8. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
15. Screw
16. Hook
17. Groove
18. Bumper
19. Hammer case cover
TD0101/TD0101F
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 3,600
0 - 3,200
100 N•m
184 mm x 67 mm x 192 mm
0.99 kg
/II
GEB136-1