Tabla de contenido
8. FLUSH OUT THE TUBING
Turn the main water supply on and
flush out the tubing until the water
is clear.
Shut the water
off
at the water
valve after about one quart of
water has been flushed through the
tubing.
10. TURN THE WATER
ON AT THE SHUTOFF
VALVE
Tighten any connections that leak.
9. CONNECT
THE TUBING
TO THE
REFRIGERATOR
Before making the connection
to the refrigerator,
be sure
that the refrigerator
power cord is not plugged
into the
wall outlet.
1. Remove the plastic flexible cap from the water valve.
2. Place the compression nut and ferrule (sleeve) onto the
end of the tubing as shown.
3. Insert the end of the copper tubing into the connection
as far as possible. While
holding the tubing, tighten the
fitting.
Tubing Clamp _
1/4 in.
Compression
Nut
_
Ferrule
(sleeve)
1/4 in. Tubing
l
)
erator
Connection
_,CAUTION:
Check to see if leaks occur at the water line
connections,
11. PLUG IN THE
REFRIGERATOR
Arrange
the coil of tubing
so that
it does not vibrate
against
the back of the refrigerator
or against
the wall.
Push the refrigerator
back
to the wail.
///
12. START THE ICEMAKER
Turn the icemaker ON at the control panel.
The icemaker will not begin to operate until it reaches
its operating
temperature
of 15°F (-9°C) or below. It
will then begin operation
automatically
if the icemaker
button has been turned ON.
37
Capítulos
Tabla de contenido
