Operating Procedures - Aimpoint Micro H-2 Manual De Usuario

2.2 OPERATING PROCEDURES

2.2.1 Zeroing
The sight is delivered with the red dot in a centered position. Normally
this means that only small adjustments are necessary, providing that
the weapon rail (Picatinny/Weaver rail) is properly aligned.
CAUTION: Do not continue to adjust windage and elevation
mechanisms if you encounter resistance.
a Open Lens covers (11) (12).
b Turn the Rotary switch (8) clockwise until the red dot has a
suitable intensity to contrast against the target.
c To access the Elevation adjustment screw (4) and the Windage
adjustment screw (5), remove the Adjustment cap (2) and the Cap
(3). See Fig. 2.
d The Adjustment Cap (2) or the Tool (13A) must be used to turn the
Adjustment screws. Place the knobs on the Adjustment cap (2) into
the recesses on the Adjustment screws (4) (5). See Fig. 3.
3
4
5
Fig. 2 Remove caps
8
4
2
Fig. 3 Adjustment cap
5
2