dBTechnologies es602 Manual Del Usuario página 33

English
To properly install the ES 602 / ES 802 speaker:
• Perform the connection to the main input (1) using a cable equipped with a XLR (balanced) or TRS
(unbalanced) connector. For an overview of the most common cables available for audio connection
please refer to the table below. Depending on the source (line/mixer or microphone), set the relevant
selector (8) to the appropriate value. Turn the MASTER CONTROL (4) volume to the minimum level.
• If any, connect the secondary stereo input with RCA-type cables, setting the AUX VOLUME (6) to the
minimum level. Later you'll be able to mix the signal from this auxiliary input with the main input
signal, through the respective volumes. Remember that the MASTER CONTROL (4) still controls the
overall system output volume.
• Temporarily set DSP PRESET (5) to FLAT.
• Using the supplied SPEAKON cable, connect the output of the TOP OUTPUT MONO (11) output to the
ES-TOP A input, for both one (ES 602), and two (ES 802) satellite installations.
• Insert the power supply connector into the relevant input (10), then turn the POWER selector to
position "I".
• The PEAK LED (3) temporarily lights up, then it goes off
• Progressively increase the master (4) and auxiliary (6, if any) volumes
• It should be noticed that the ON-SIGNAL LED (3) blinks to indicate the presence of the input audio
signal
• Use the DSP PRESET (5) position that is the most appropriate for the application.
ES 602 - 802 REV. 1.1 Cod. 420120228 REV. 1.2
33