UFESA CF Nepal Manual De Instrucciones página 23

3. Insert down rod to hanger (Figure 5), line up hanger holes with down rod holes and insert
bolt. Then insert pin to end of bolt.
4. Finally secure down rod and hanger by tightening two screws (Figure 6).
HANGING THE FAN
1. Lift fan assembly onto mounting bracket (Figure 7).
2. Rotate the fan down rod by hand and ensure the notch of the ball joint is positioned on
the stopper of mounting bracket to prevent fan from rotating when in operation (Figure 8).
CONTROLLER KIT INSTALLATION AND POWER WIRING
WARNING: Disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location before wiring power cables.
1. Install the receiver in the mounting bracket (Figure 9)
2. Connect the power input wires to the electrical power supply wires (Please contact a
qualified electrician if you don't know how to do it).
Insert the Motor Input Connector, LED Light Power Connector and Power Input Connec-
tor into corresponding sockets on the Receiver (Figure 10)
3. Tuck all wires and the antenna into the canopy. Push the canopy upwards, lining up the
keyholes on the bottom with the screws on the hanger bracket. Twist the Canopy to lock
it in place and then tighten the screws to secure it. (Figure 11)
FAN BLADES INSTALLATION
1. Install the blade onto the motor with the provided screws (Figure 12).
2. Repeat with the remaining blades.
INSTALLING THE LED LIGHT KIT AND LAMP SHADE
CAUTION: To reduce the risk of electric shock, disconnect the power supply circuit to the
fan before installing the Light Kit.
1. Loosen the three mounting screws on the mounting ring.
2. While holding the LED Light Kit under the fan motor, pass the light power wire through
the hole in the center of the light kit and plug the light power wire connector into the
socket on the lighting kit (Figure 13).
3. Carefully position the 3 screw holes on the Light Kit to match the 3 screw holes on the
mounting ring. Secure it by placing and tightening the three mounting screws (Figure 14).
4. Lift the Lamp Shade against the Light Kit and turn it clockwise until tight, DO NOT
OVERTIGHTEN (Figure 15)
REMOTE CONTROLLER INSTRUCTIONS
1. LED indicator light
2. Appliance power off button
3. Light on/off button (Include change the light models)
4. Fan speed buttons (1 min. - 6 max.)
5. Fan on/off button
6. Timer (1h, 4h, 8h)
7. Natural air mode
8. Anti-theft mode
23